I've been playing around etching some pcb's and will have a separate post on that later on. I needed to burn the arduino bootloader on a atmega328. Usually I put it in the dragon, connect a bunch of jumper wires and burn away. of course I sometimes get wires in the wrong spot and what not. Some time ago I saw someone had made a bunch of pcb jumper boards for the dragon. You just plug in the board and burn. I couldn't find them. I found pictures of them, discriptions of them, but no pcb layouts.
So I made my own. So far I have made one for the atmega 168/368 that does ISP programming. I didn't put a crystal or anything on it as I am usually burning blank chips (internal 8mhz osc /8 = 1mhz).
I used mostly female headers on my dragon so I could just stick plain jumper wires in rather than need special female jumpers. Exceptions are the ISP and JTAG Headers, they need to be male for connecting to boards. I only placed headers on the jumper board where I needed them.
Top of board
Making things out of Metal, Plastic or Even PCBs
1 post • Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 1 guest